Added sleeving to the wires to the strip lights and attached the controllers to the underside of the tower top deck.
Another view.
Lots and lots of wires.
My inexperience is sleeving shows here. I'm going to hold off doing any more until I have my heat gun so I can heatshrink the ends. Also, I'm going to strip the clear covering off the sets of wires so it will be a much smaller bundle. I'll also use heat shrink inside so there aren't any wire ties inside.
Same thing goes for the top. Also, the controllers aren't staying with the stick velcro. They'll have to be mounted differently.
Here's where I started wrapping the temp sensor wires with wire wrap. I like the sleeving better, so I'll probably go back to that.
I placed some empty sleeving from the tower to the control center and the green wrap kinda like the temp sensors will run. So you can see kinda how the colors will look. Of course, the wires will be suspended a little different and there will also be two green ones from the tower aliong with the orange ones.
